Summary and Next Steps

A recap of building, animating and coding a robot arm in Snakie, with the finished project files and where to go next

By Kevin McAleer,    4 Minutes

Page last updated November 21, 2026


Course Cover Image


You built a robot

You started with an empty 3-D view. You now have a three-joint desk arm that you designed, weighed, posed, animated and drove from MicroPython, all without a single part on your desk.

That’s the big idea of the Build workspace: work it out on screen first. Mistakes cost nothing, and by the time you print and wire the real thing you already know it moves the way you want.


What you learned

Lesson Skill
1 to 3 Finding your way around Build, adding and sizing blocks, and joining them face to face
4 Fixed, Hinge, Wheel and Slider joints, axes and limits
5 Mass estimates, balance, ground contacts, Bone Mode and measuring
6 to 7 Posing with sliders and by dragging, and saving poses to the shelf
8 to 9 Building a motion on the Timeline and fine-tuning it with joint tracks and keyframes
10 to 11 Binding servos to joints and driving the model from your own code
12 Exporting a motion as a MicroPython program
13 to 14 URDF export and import, BetterCad robots, and rendering a movie

The finished project

If you’d like to compare your arm with ours, or start from a known-good copy, here are the files.

Put robot.urdf and robot.yml in a new folder, open it in Snakie and switch to Build.


From screen to desk

When you’re ready to build an arm for real:

  1. Design the parts. Blocks show you the sizes and the pivots. Draw the real parts in BetterCad around your servos
  2. Bring them back. Export the URDF from BetterCad and open it in Snakie, as you did in lesson 13
  3. Reuse your motion. Bind the servos to the same pins and export the code again
  4. Wire it and run it. Three servos want their own 5 V supply, with the grounds joined to the Pico

Challenges

  1. Add a gripper. Two small blocks on Slider joints at the end of the forearm. Set one to copy the other so they close together
  2. A pick and place. Save poses for above, down, lifted and across, and chain them on the Timeline
  3. A different robot. Build a two-wheeled rover from a body block and two Wheel joints, tag its contacts and check it balances
  4. Button control. Change the exported program so the motion plays once each time a button is pressed

What’s Next

Build something, make it move, and share the movie. We’d love to see it.


Check your understanding

Quick quiz 1 of 3

What is the main benefit of building a robot in Snakie before printing it?

Quick quiz 2 of 3

Which file holds your poses, motion and servo bindings?

Quick quiz 3 of 3

You want two gripper fingers to move together from one servo. Which joint setting helps?

< Previous

You can use the arrows  ← → on your keyboard to navigate between lessons.

Course complete

Congratulations, you finished Build and Animate a Robot in Snakie!

That's all 16 lessons done. Let people know, it's a great way to inspire someone else to start.

Share card: I completed Build and Animate a Robot in Snakie on KevsRobots
Post Bluesky LinkedIn Facebook


What are you looking for?
Watch Videos Get Ideas Learn Something Read a Review Read the Blog Search
... Z Z z