KevsRobots Learning Platform
Build a SMARS Robot in Fusion 360
36% Percent Complete
Overview
Create the Base
Refine
Wheels
Motor Holders
Front
Wheel
Final Design
Motor holder profile
Create the motor holder profile
By Kevin McAleer, 1 Minute
The profile for the motor holders within the body is created next. There are a couple of dimensions on this sketch:
- motor holder side wall thickness = 2mm
- motor holder side wall edge from body edge = 16.5mm
- motor holder wall height = 29.50mm
- unpowered wheel block from case edge = 13mm
- unpowered wheel block and battery nub from edge = 19mm
- battery nub height = 10mm
- battery nub thickness = 3mm
The top half of the sketch can be created and then a circular pattern used to rotate this around the centre to create an asymetric mirror for the bottom half of the sketch.
You can use the arrows ← → on your keyboard to navigate between lessons.
Comments