Summary and Next Steps

A recap of Print It Right with BetterCad, a pre-flight checklist to keep by the printer and where to go next

By Kevin McAleer,    4 Minutes

Page last updated November 20, 2026


Course Cover Image


You’ve been through the Print panel from top to bottom, calibrated your printer twice and finished with a box whose lid fits because you decided it would. Most of what separates a frustrating print from a good one happened before the slicer opened.

The box with a lid


What you covered

Lesson The question it answers
Set up your printer Does it fit the bed?
Overhangs and supports Will any of it print in mid-air?
Thin walls Is anything too thin to exist?
Choosing an orientation Which way up is strongest and cleanest?
Holes that fit Will the screw go in?
Fits between parts Will the parts go together the way I want?
Where parts meet Did I leave a gap everywhere I meant to?
Material and weight How much plastic is this?
Exporting for your slicer Which file, at what resolution?

Your printer’s numbers

Fill these in and keep them. They’re saved in your BetterCad printer too.

Setting Default Mine
Hole offset 0.4 mm  
Press fit 0.15 mm  
Sliding fit 0.25 mm  
Loose fit 0.4 mm  
Lid gap that works 0.3 mm  
Steepest overhang I trust 45°  

Print the two calibration plates again when you change material, nozzle or printer.

The pre-flight checklist

Before every export:

  1. Printer picked, and the panel says the model fits
  2. Overhangs checked. Anything large is turned, chamfered or accepted
  3. Thin walls checked
  4. Orientation chosen for strength first, supports second, looks third
  5. Holes made with the Hole tool at your offset
  6. Where parts meet checked with the parts assembled. Nothing too tight
  7. Export 3MF at Normal, placed on the bed
  8. Save the .bcad

The ideas worth keeping

  • Printers are consistent, not accurate. Yours is wrong by the same small amount every time. Measure that once and design for it
  • Offsets go on diameters, gaps go on each side. A 0.4 mm hole offset and a 0.2 mm fit gap are the same clearance
  • Orientation is free. It changes strength, finish and support, and costs nothing
  • Layers are grain. Lay the part so the load runs along them
  • Checks are guides. The overhang check doesn’t know about bridges, and the thin wall check samples. The slicer preview has the final say
  • Change one thing at a time. When a fit is wrong, adjust the gap by 0.05 mm and reprint the smallest part

What’s next


Try it Yourself

  1. Fill in the table of your printer’s numbers.
  2. Take a part you designed before this course and run it through the pre-flight checklist. What does it find?
  3. Design a holder for something on your desk, using at least one hole from the Hole tool and one fitted cut.

Check your understanding

Quick quiz 1 of 3

When should you print the calibration plates again?

Quick quiz 2 of 3

A 0.4 mm hole offset is the same clearance as which gap each side?

Quick quiz 3 of 3

Which has the final say on whether a wall will print?

< Previous

You can use the arrows  ← → on your keyboard to navigate between lessons.

Course complete

Congratulations, you finished Print It Right with BetterCad!

That's all 12 lessons done. Let people know, it's a great way to inspire someone else to start.

Share card: I completed Print It Right with BetterCad on KevsRobots
Post Bluesky LinkedIn Facebook


What are you looking for?
Watch Videos Get Ideas Learn Something Read a Review Read the Blog Search
... Z Z z