By Kevin McAleer, 3 Minutes
Page last updated November 20, 2026

You started with a single board on a blue canvas. You’re finishing with a wired, checked, documented and programmed robot. Nice work.
| Lesson | The big idea |
|---|---|
| The workspace | A canvas for parts, a Browser for the project and a Library to draw from |
| The Parts Library | Every part knows its own pins. Read the pinout before you wire |
| Placing parts | Arrange first. Short wires that don’t cross are easy to follow |
| Wiring | Power, ground and signal. And never forget the shared ground |
| The Schematic | The same circuit, drawn to show what connects to what |
| The rules check | Make your mistakes on screen, where they cost nothing |
| Drivers and help | Pin numbers in code come from the wiring diagram |
| Connections and measurements | The table is the truth. Check your build against it |
| Exporting | A build guide with a tick-box per wire beats a photo |
| The robot | Plan, wire, check, document, code, build |
If you take one thing from this course, make it the order of work:
It feels slower. It’s much faster, because you only build the circuit once.
Carry on with Snakie
Go deeper into robots
Learn the language properly
One last challenge. Design a circuit of your own from scratch: pick a sensor you haven’t used from the Library, read its help page, wire it to a Pico, check it, and export the build guide. You now know every step.
Quick quiz 1 of 3
What’s the right order of work?
Quick quiz 2 of 3
Which wire do beginners most often forget?
Quick quiz 3 of 3
Which view is best for understanding what connects to what?
You can use the arrows ← → on your keyboard to navigate between lessons.
Comments