Cubie-3 - Wiring
An open-source 3d printable cube robot you can build yourself
Video
For every project I create, I often make a corresponding YouTube video. Sometimes, there might be more than one video for a single project. You can find these videos in this section.
Explore more through this this dedicated video.
Raspberry Pi Camera cable
- Black section of the ribbon cable faces the USB ports on the Raspberry Pi.
- The camera cable connects to the Camera port on the Raspberry Pi 5 and the Camera Module v3.
- The Black sesion of the ribbon cable faces you when looking at the back of the Camera Module v3.
Battery
- The battery connects to the Sunfounder Fusion HAT+ via the JST connector.
Motors
- Each motor connects to the Sunfounder Fusion HAT+ via the white 2 pin connectors. Unsoldered cables are provided, these will need to be soldered to the motor wires.
- For consistency, when wiring up the n20 motors look for the tiny
+symbol on the motor PCB and connect the red wire to this side.
You can use the arrows ← → on your keyboard to navigate between lessons.