108640 Views
83860 Views
59555 Views
48723 Views
48311 Views
47806 Views
KevsArcade
C2Pi-O Laser cut Camera holder
Build a laser-cut robot
Robots and Lasers
Arduino Plug and Make Kit Review
Pi to Pico W Bluetooth Communication
Getting Started with SQL
Introduction to the Linux Command Line on Raspberry Pi OS
How to install MicroPython
Wall Drawing Robot Tutorial
BrachioGraph Tutorial
Intermediate level MicroPython
KevsRobots Learning Platform
36% Percent Complete
By Kevin McAleer, 1 Minute
The motors are kept in place by the motor holders. You will have to bend these slightly to insert them into the little recess just about the motors. It is also good practice to push the motor wires through these before inserting. This will make them fit snug and will allow the motor wires to be free and untrapped.
< Previous Next >